P2.25
PERFORMANCE SERIES 2 x 1300W @ 8ohm 2ru
Installation
Features
- Housed in a rugged, all-steel 2U chassis
- Rear panel selection switch for stereo, parallel and bridged modes
- Operates within 8Ω and 4Ω loads
- Innovative heatsink with front to back air flow for efficient cooling
- Variable fan speed is automatically adjusted by temperature
- Electronically balanced XLR inputs
- Balanced XLR through connectors
- Precision indented level controls
- Front panel power switch
- Protect, limiter and signal LED indicators for each channel
- Amplifier protection includes short circuit, excessive temperature and DC on outputs
Cabinet Dimensions
Specifications
| Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF): |
2x 1300W 8 ohms 2x 2500W 4 ohms |
|---|---|
| Overall gain: | 34dB (50 times voltage) |
| Sensitivity at 8 ohms: | 1.8Vrms (+8.4dBu) |
| Signal to Noise Ratio (A weighted, 0dB): | 110dB |
| Frequency Response (-1dB): | 10~25000Hz |
| Typical THD (half power, 1kHz, 8 ohms): | 0.05% |
| Typical IMD (1kHz at 4:1, -20dB): | <0.2% |
| Crosstalk (1kHz): | >70dB |
| Slew Rate: | >20V/us |
| Input Impedance: | 20 kΩ |
| Damping factor (1kHz, 8 ohms): | >800 |
| Protection: | Soft-Start, Short-Circuit, Over and Under-Voltage, Over-Current, Over-Load, DC Output, Temperature, SOM (Smart Overhead Management) |
| Operating Voltage: | 190~260VAC 50-60Hz |
| Preamp: | Proprietary PureSound Circuit for unmatched sound quality (Audiophile capacitors in signal path, High Voltage Opamps, Ultra Low Noise design) Studio grade TrueRMS VCA limiter Continuous protection, RF protection, Overload protection |
| Power Supply (PSU): | Advanced Linear topology with tracking current 105C long life SuperCharged Capacitors |
| Output stage: |
Fully Discrete 4th generation proprietary Class D (93% efficiency at full power) Half bridge design with high-Speed high-Current MOSFETs 105C Long Life capacitors |
| Cooling: | Front to back airflow Temperature regulated SUNON MagLev fans (50000 Hours, dustproof) FEA optimized Radial heat-sink for maximum heat transfer |
| Rear Panel: |
2 NEUTRIK XLR Input with latch PowerCon connector power cable supplied |
| Speakon Wiring: | SPK1 = 1+1- CH A / 2+2- CH B SPK2 = 1+1- CH B / 2+2- Not Used |
| Net Weight: | 18Kg |
| Gross Weight: | 19.5Kg |
| Dimensions (W x D x H): | 397 x 388 x 88mm |
| Packaging Dimensions 1pcs/pack: (W x D x H) |
570 x 530 x 180mm |
| Warranty: | 5 Years |
